That's not going to work with a uZeus even with the bigger power supply - max -ve rail is 500mA - which means you want to keep below 400mA (preferably less) - otherwise expect power problems
I'd try to change to a power supply that has at least 750mA available on the -ve rail & preferably one without the rack wart
I'd recommend the tiptop studio bus - but you'll need 2 busboards otherwise you probably won't have enough power on the +12v - and you still get a rack wart
I like the befaco excalibus - you'd need 2 though, but no rack wart! - so 4hp more to play with! just a hole in the case to take the power cable(s)
otherwise if it were me I'd probably swap the dipole for a blades - or something smaller like a wmd overseer and the pico dsp for a fx aid (get the xl if you can - better ergonomics and more modulation inputs)
-- JimHowell1970
Ooof, well since I already ordered the uZeus i'll start with it and then get something more powerful after passing 400mA on the negative. Thanks for this info especially.
I'll also definitely check out blades, overseer and fx aid as replacements for the other modules. Thanks a lot!
EDIT: I haven't gotten into making solid racks so the flying bus boards were tempting with the uZeus. Question: Do i need anything special or just make screw holes, screw in the bus boards and connect them to a power supply?