Offer Details

The JHS NOTADÜMBLË is a DIY pedal that puts a half-million dollars of tone at your feet. you can go between two highly sought after sounds that are as magical and rare as it gets. In the Drive setting–slider up–you get the dirty and distorted violin-like sounds you know from guitarists like Santana, Joe Bonamassa, and Eric Johnson. In the Clean position–slider down–you get a powerful preamp buffer pulled directly from John Mayer's rare and never before replicated device, the Dumble BBC-1.The Cosmodio Deluxe mod transforms the JHS NOTADÜMBLË into a fully-capable dual drive pedal. It puts a dedicated true-bypass stomp switch for each of its two channels, allowing for easier switching, as well as adding the ability to activate both channels & stack them in series, creating vast possibilities that are not available in the original design. Furthermore, we add a "FLOW" switch to direct signal flow, letting you determine the stacking order -- from clean into overdrive, or overdrive into clean.JHS's Dumble-inspired audio circuits themselves are completely intact & unmodified. By activating one channel at a time you can still achieve 100% of the sounds available from the original design. But by adding the ability to flexibly combine these two circuits you are able to get far more out of them, dramatically opening up new sound sculpting & dynamic performance possibilities.The Mod really opens up the possibilities of this pedal – the channels still sound amazing on their own, but when you stack them, things really start to take off. ... This particular mod creates basically an entire new pedal, while retaining the sound & legacy of the original.JHS ships the NOTADUMBLE with a presence control (for boosting or cutting upper-mid frequencies of the overdrive channel. Think of it as a "brightness" control.), which is located on the inside of the pedal as a small "trim pot" which can be turned by screwdriver. This deluxe mod moves this control to a proper potentiometer with a knob located on the faceplate in the position of the stock channel switch. This doesn't change the sound capabilities of the pedal, but makes it much easier to adjust presence as you would any of the other controls. We find it makes the overdrive channel far more flexible and usable. Requires 9VDC center negative and consumes 10mA. Do not use more than 9VDC. Damage may occur. This pedal measures 3.7” X 4.7” X 1.66”