ModularGrid uses so-called cookies to ensure it's so-called functionality. We also use dubious tracking scripts. Find out more in the Privacy Policy. We use cookies and wanna let you know.
Got it.
If you had an Unicorn Account you could see a chart with the price development of this module and the average price asked for this module.
The RAT is renowned for its sonic flexibility. That said, the Pro Co FAT RAT takes this versatility to a whole new level. Like the original RAT, this distortion pedal includes a silicon clipping circuit, yielding you the classic harmonic-rich sound that's been a pedalboard staple for more than four decades. But unlike its predecessor, the FAT RAT includes a selectable MOSFET clipping circuit, supplying you with a smoother upper midrange than a standard RAT, along with an amp-like tone that's guaranteed to inspire. What's more, the FAT switch produces thunderous low end and a simultaneous high cut that's tailor-made for bass and down-tuned electric guitars. This amazing dirt box boasts a familiar 3-knob layout, along with a rugged on/off footswitch and a status LED. The FAT RAT comes complete with solderless op-amp swapping and 18-volt operation for increased headroom.A RAT modder's dream come trueBy the turn of the millennium, RAT mods had become a dime a dozen. Boutique pedal builders had found a zillion ways to retool this classic circuit, swapping out op-amps and clipping diodes to produce never-before-heard sonic textures. The FAT RAT captures this trend perfectly. A switchable clipping section toggles between the standard silicon circuit and a MOSFET-based one, arming you with an amp-like tone and feel that are still decidedly RAT-ish. You also get a bass enhancement circuit that lends the perfect amount of low-end juice to bass and down-tuned guitars. To top it off, the FAT RAT enables solderless swapping of its OD07DP op-amp with an LM308 or another compatible chip. High-fidelity 18-volt operation rounds out the FAT RAT's impressive enhancements.Dial in a wide range of useable tonesThe Pro Co FAT RAT includes the same intuitive top-panel controls as its forerunners: Distortion, Filter, and Volume. You use the Distortion knob to dial in the total amount of saturation. At its minimum setting, this control acts as a fuel-injected dirty boost; at maximum, it delivers harmonic-laden fuzz tones. The Filter knob gives you lots of sonic flexibility. Turn the control counterclockwise for mix-piercing tones with lots of clarity; twist it clockwise to roll off your highs for a warm, cranked amp-like tone. The Volume knob adjusts your total output level. You can run the FAT RAT at unity gain for a bit of added grit or crank it to punish the front end of your amp. Countless guitarists have a RAT on their pedalboard — it's a must-have stompbox.Pro Co FAT RAT Pedal Features:Delivers the famous silicon-based, hard-clipping distortion that the original RAT made famousSelectable MOSFET clipping circuit yields you an amp-like tone and feel that are still decidedly RAT-ishFAT switch produces thunderous low end that's tailor-made for bass and down-tuned guitarsDistortion knob dials in the total amount of saturationFilter knob conjures up a myriad of sonic texturesVolume knob adjusts your total output levelEnables solderless swapping of the included OD07DP op-amp with an LM308 or another compatible chipHigh-fidelity 18V operationNear-bulletproof metal enclosureRugged on/off footswitch and status LEDWarranty Info
This offer was fetched from reverb.com. You cannot contact the seller via ModularGrid. You have to visit their site.
Look up onDisclaimer: Modules listed for sale on the ModularGrid Marketplace are offered explicitly by their respective owners. ModularGrid is not affiliated to the sellers and takes no legal responsibility in any transaction.
The internet is a rough place and fraudulent behavior can occur. If you are concerned about dealing with strangers consider buying your module at an authorized dealer.