PM pre-out breakout expander

PM pre-out breakout expander

This page is a conceptual module specification for the purposes of gathering community feedback. This module is not currently available.

Discussion on this module concept can be found on Modwiggler: https://www.modwiggler.com/forum/viewtopic.php?t=274484

Overview

An expander module for the WMD performance mixer that outputs channels 1-10 and main pre-fader outs on a separate 6hp breakout module.

Module output jacks:

• Mono channels 1-6
• Stereo channels 7-8
• PM Channels 9-10 (Optional - disconnected if PM channels is not present)
• Stereo out (effectively active multing the stereo outs on the Performance Mixer)

This module is a community-created, creative commons licensed module that is not designed, affiliated or endorsed by WMD.

This module was designed by Pete Baker in Oakland, California. Thanks to WMD and the Modwiggler community for tips that led to the design of this module.

Use cases

Connect pre-fader outs from any PM channel to other modules,

• e.g. a sound card such as ES-9 to record mixed channels
• bus channels for bus FX
• +other creative uses

Technical specifications

Outputs

• Mono channels 1-6
• Stereo channels 7-10 (9 and 10 require PM channels)
• Main stereo out

Output impedance

• 510R - all channels

Inputs

• None

Controls

• None

Power consumption

• None - module is passive

Dimensions

• 6HP
• TBDmm deep

Rear connectors

• 20-pin PM pre-outs connector (mono 1-6, stereo 7-8)
• 10-pin PM channels pre-outs connector (stereo 9-10)
• 6-pin main connector (main L & R)

https://peteb4ker.notion.site/PM-pre-out-breakout-expander-b585194672434d47b013a79d81d24c03