Eurorack to ILDA Laser creative analog interface

The EOTB is an analog Eurorack interface that allows you to use modular signals to control any laser device equipped with an ILDA port (the old school DB-25 connector). Please note that I refer to lasers like the Laserworld DS series or similar. Last but not least, EOTB is an INTERFACE, so it can generate RGB colors, but you still have to feed it with your own signal source like VCOs or LFOs to move the laser beam.

More info at BÈSIA Modular shop

Featuring:
- Full analog circuit!
- Differential low impedance output on DB25 as required by ILDA standard
- A Low Pass Filter in the middle of X/Y signal path to enhance your creativity
- Individual controls over X and Y scale with semi-normalled VCAs
- Onboard RGB offset generator and RGB led
- DC coupled signal path

Manual and voltage control over:
- R, G, B levels with dedicated attenuators
- X, Y positions and scales
- LPF cutoff

Plus: X/Y buffered outputs, X/Y inverters, interlock on/off switch, rear microswitches (3 settings) to adjust the cutoff point of LPF to protect the galvoscanners.

https://besia.bigcartel.com/product/eye-of-the-beholder